Yamaha SRX440 1980 Service Manual page 21

..
_---_._--
1980 SRX440
4. By moving the water pump housing up
and down, adjust the belt tension.
Adjust the bolt so that the belt deflects
4 mm (0.16 in) when a force of 4 kg (9
Ib) is applied to the center of belt.
F: 4 kg (9 lbl
a:
Center of belt
S: 4 mm (0.16 in)
5. After adjusting the belt tension, tighten
the water pump housing bolts.
Tightening torque:
9.5 Nm (0.95 m-kg)
F.
Starter
1. Install the starter spring in the starter
case.
NOTE: - - - - - - - - - - - -
1. It is necessary to wind the spring to a
small size before installing it in the
starter case.
2. Be careful not to install the spring in a
wrong way.
3. Hook the loop on the outer end of the
spring onto the spring hook in the
starter case. Then thoroughly grease
the s rin .
2.
Windihe starter rope- -around the
sheave drum, and put it into the star- .
ter case.
Hook the knot on the rope end onto
the cut in the sheave drum (as il-
lustrated), and wind the rope around
the sheave drum in the direction of
the arrow, leaving about
370
mm
(14.6 in).
The other end of the rope is con-
nected to the starter handle.
2-15
3. Bring the rope end out of the cut in
the sheave drum, and turn the sheave
drum 4 tu;hs counterclockwise to
give the starter spring preload. Pull
the starter handle and release it, mak-
ing sure that the starter handle re-
turns to the housing rope eye.