Rear Suspension - Yamaha SR1NLK Operator's Manual


NOTE: To verify everything is
installed correctly, turn the exten-
sion counterclockwise. The notch in
the extension should not rotate out
of the detent block.
10. Rotate the extension clockwise
approximately 20° making sure not
to pull out the extension when rotat-
ing. This is only to aid in the instal-
lation of the actuator.
11. Install the actuator and secure using
the existing three Torx screws.
Tighten to 0.4 kg-m (36 in.-lb).
12. Connect the harness to the gear posi-
tion sensor; then secure the connec-
tor to the main harness using a cable
tie.
13. Install the resonator and secure
using existing hardware.
14. Install the lower console; then install
YM-102
the seat, hood, and both access pan-
els.
15. Start the engine; then shift the snow-
mobile into and out of reverse three
times.

Rear Suspension

This procedure should be done every 40
operating hours.

NOTE: Yamaha recommends that
Low-Temp Grease be used for this
procedure.
1. Using Handlebar Stand or Steering
Post Stand or a suitable substitute,
lay the snowmobile on its left side.
2. Lubricate all grease fittings with
low-temperature grease.
SNO-1247A
19