Yamaha SRX440 1980 Service Manual page 58

1980 SRX440
3. Insta lIation
a. When installing the wheel sprocket to
the front axle. position the wheel
sprockets on the front axle as shown.
Use a press.
115.6 mm (4.55 in)
I
29.6mm
'(1.17ini
46mm
(1,81 in)
J
-
57mm
(2.24 in}
46mm
(1.81 in) 75.9 mm (2.99 in)
161.9 mm (6.37 in)
b. Be sure the sprocket teeth are aligned
as shown. After positioning, tighten the
band.
Tightening torque: ./
5 Nm (0.5 m-kg)
c. Apply a low temperature grease to the
chain case oil seal, and insert the right-
hand side of front axle into chain case
through drive track.
Tighten the front axle with chain driven
sprocket.
5-14
Tightening torque:
50 Nm (5.0 m-kg)
d. Install the front axle housing. Next, in-
stall belleville washer and front axle nut.
Tightening torque:
Front axle housing:
23 Nm (2.3 m-kg)
Front axle nut:
85 Nm (8.5 m-kg)