Yamaha SRX440 1980 Service Manual page 10

1980 SRX440
3. Using the flywheel puller, remove the
flywheel assembly.
F. Oil pump
1. Remove the oil delivery pipes.
2. Remove the bolts and pump drive case.
E. Primary sheave
Refer to "5-1-8. Primary sheave"
Tool No.
90890-01235 Rotor holding tool
Tool name
1. Rotor holding tool
No. Tool name
Drive handle
Tool No.
90890-01817
NOTE: - - - - - - - - - - -
The oil pump can be removed as an
assembl to ether with the um drive
4
Flywheel puller screw
(q\8
X 80
mm)
90890-01806
cover. If it is hand to remove the pump drive
case. tap it with a soft-faced hammer.
3. Remove the Phillips-head screw, and
remove the coil plate.
N O T E : - - - - - - - - - - - -
When removing the flywheel, the key must
be removed from the crankshaft.
Take care so that it is not lost.
C A U T I O N : - - - - - - - - - ,
The oil pump must not be disassembled,
because the oil pump is a precision
work.
3. Remove the oil pump cap and pump
wire.
4. Remove the oil pump assembly.
G. Engine disassembly.
1. Remove the thermostat case and joint.
90890-01804
Flywheel puller
attachment
5
2-4
L