Brake; Disassembly; Inspection - Yamaha SRX440 1980 Service Manual

1980 SRX440
5-2.
BRAKE
.
(?J'
9.5 mm 10.37 ;nl ..,......
~I
II:
I
I
I
CD
13.5mm(O.68inl
~
3. Remove the brake pads.
Wear limit: 9.5 mm (0.37 in)
A. Disassembly
1. Remove the brake cable from the brake
caliper.
2. Remove the brake caliper assembly.
NOTE:
- - - - - - - ~ - - - - ­
For brake disc removin refer to "5-1-E-1.
B. Inspection
1. Check the pads for damage and wear. If
the thickness is less than specified
below, replace pads as a set.
Chain housing".
f. Install the chain housing cap and add oil.
(See "5-1-E-4. Chain housing")
g. Install the slide rail suspension assemb-
ly.
(See "5-3-D. Suspension installation")
h. Fill up the meter housing with a low
temperature grease and install it.
Guide wheel collar tightening torque:
5.5 Nm (0.55 m-kg)
Tightening torque:
6 Nm (0.6 m-kg)
e. Set the left side guide wheel 46 mm
(1.81 in) from the left sprocket wheel
side.
<,=FWD
5-15
1. New
2. Wear limit
2. Check the brake disc for warpage. If
warped, replace.
3. If the brake lever will not return
smoothly to the rest position because of
a fatigued return spring. replace the re-
turn spring.