Reassembly; Adjustment - Yamaha SRX440 1980 Service Manual

1980 SRX440
C. Reassembly
1, Apply a low temperature grease to the
back up plate shaft and screw cam,
2,
Install the brake caliper with brake' pads
to the chain housing,
Tightening torque:
50 Nm (5,0 m-kg)
brake lever.
C A U T I O N : - - - - - - - - - . . . ,
Apply a small amount of antifreeze
grease to the contact a reas of the brake
cable with brake lever stopper surface.
but do not apply a grease between the
outer cable and inner cable.
D. Adjustment
1, Left-hand brake adjustment
a, Loosen the brake cable lock nut. and ad-
just the brake cable adjusting bolt so
that the brake inner cable does not
touch the brake caliper (the brake
caliper and brake inner cable must be in
a straight ine). Then tighten the lock nut.
5-16
1. Lock nut
2. Adjusting bolt
b, Loosen the lock nut. and turn the ad-
justing screw so that the brake cable
has a play of approx, 5 mm (0,20 in) at
the brake lever holder, Then tighten the
lock nut,
1. Adjusting screw
2. Lock nut
2, right-hand brake adjustment
The right-hand brake is adjustable by
turning the adjuster of the right brake
cable, To adjust. loosen the adjuster
lock nut first and turn the the adjuster in
and out so that the brake wire has a
play of 5 mm (0,20 in) at the brake lever
holder, After adjustment. tighten the
lock nut.