1980 SRX440
3. Starter cable adjustment
Pull the starter cable outer tube upward,
and adjust the free play between the
outer tube end and adjuster to specifi-
cation by turning the adjuster. After the
adjustment, tighten the lock nut and re-
place the rubber cap to keep the lock
nut free from dust and water.
NOTE:
-----------~
Starter cable free play must be adjusted after
the cable is correctly routed. (Refer to Cable
routing diagram.)
Lock nut tightening torque:
0.08 m-kg (0.6 ft-Ib)
a. Tighten the pilot screw lightly, and back
it out from its lightly seated position.
Standard pilot screw (turns out):
2.0
1. Pilot screw
NOTE: - - - - - - - - - - - -
Make certain that both throttle valves are ad-
justed to the same opening.
Idling engine speed: 1,500 r/min
b. Start the engine by pulling the starter
lever, and fully warm up the engine.
c. Set the throttle stop screw so that the
CD
2
'.5""'" 2.5 mm (0.06 ':" 0.' 0 in)
1. Adjuster
2. Lock nut
Free play between outer tube end
and adjuster:
15
~
2.5 mm (0.06
~
0.10 in)
4. Oil pump cable adjustment
Refer to "2-2-8-5. Pump cable adjust-
ment",
5. Low speed tuning
The carburetor is built so that low speed
tuning can be done by adjusting the
throttle stop screw and pilot screw.
1. Throttle stop screw
C A U T l O N : - - - - - - - - - - - .
Always install air silencer before mak-
ing tuning adjustment, High perform-
ance tuning cannot be done without the
silencer. Engine damage may result
from attempting to tune without the
silencer installed,
NOTE:-----~-----
If the engine shows poor performance in ele-
vation or in an extremely cold area or when it
is suddenly accelerated or run at low speeds,
proceed as follows:
1. Replace the pilot jets according to "Jet
setting chart" (See next paragraph).
Standard pilot jet: #85
4-3