3 ● Run a Job
Fill the Sealer
When the sealer unit needs
refilling, the Add Sealing Solution
icon flashes in the display.
When this happens, add E-Z Seal
Sealing Solution or water:
1. Open the sealer bottle cover
hinge located at the rear, right
side of the inserter and remove
the bottle.
2. Fill the bottle with solution or
water to the level indicated.
3. Place the sealer bottle in
position in the inserter and
close the cover.
NOTE: If the sealer unit was
completely empty, allow time
for the fresh solution or water to
soak through the sealer before
you resume operation. This helps
assure a good seal.
NOTE: We recommend Pitney
Bowes E-Z Seal to minimize algae
growth and scale build-up.
Adjust the Stacker
If necessary, adjust the drop stacker to accommodate the job material.
1. Lift the lever at the rear of the
stacker and adjust the stacker
to one of the preset positions.
2. Lower the lever to lock the
stacker into position.
NOTE: When not in use, you
can raise the stacker and latch it
vertically against the exit area of
the inserter.
3-14
®
SV63138 Rev. A