Introduction - Motorola ME-560M User Manual

INTRODUCTION

Instructions for installing your Data/Fax/Voice Modem will be found in the Installation
Manual, while the information in this manual, deals exclusively with the operation of the
modem after it is installed, such as the command set, the internal configuration registers,
troubleshooting and testing.
Features
This Data/Fax/Voice Modems combine the features of a 56000 (Receive only)
/33600/28800/14400/9600 BPS for data modem and a 14400/9600 BPS for FAX modem.
Your new Data Modem gives your personal computer the ability to send and receive FAX
messages over the telephone line like a standard FAX machine. Your Data Modem also
allows your PC to communicate with other personal computers, terminals or BBS's
(Bulletin Board Systems) through the data modem functions.
When used as a data modem, your Modem uses the standard AT command set and is fully
compatible with the specification shown in the following table,
Modem Type
K56Flex Compatible
Data Modem
ITU-T V.90 Compatible
ITU-T V.34 1996 – 33.6 Kbps to 2.4 Kbps
ITU-T V.32bis – 14.4 Kbps to 4.8 Kbps
ITU-T V.32 – 9.6 Kbps to 4.8 Kbps
ITU-T V.22bis – 2.4 Kbps
ITU-T V.23 – 1.2 Kbps/75 bps
ITU-T V22 – 1.2 Kbps
ITU-T V.21 – 300 bps
Bell 212A – 1.2 Kbps
Bell 103 – 300 bps
Automatic Mode Selection
Automatic Rate Adaption
Digital Near – End/Far – End Echo
Cancellation
ITU-T V.8 Signaling
ITU-T V.8bis Signaling
ITU-T V.54 Loopback Test support
ITU-T V.17 – 14.4 Kbps to 9.6 Kbps
Fax Modem
ITU-T V.29 – 9.6 Kbps to 4.8 Kbps
ITU-T V.27ter – 4.8 Kbps and 2.4 Kbps
ITU-T V.21 Channel 2 – 300 bps
Full-Duplex Speakerphone with Automatic
Voice Modem
Gain Control and Room Monitor
Answering Machine
Switching between DATA mode, FAX mode and Voice mode operation of your
Data/Fax/Voice Modem is done through its firmware, no hardware settings are required.
If you are already familiar with the use of a modem and the Hayes AT command set,
this modem will be extremely easy for you to use. Just read the installation procedures in
the installation manual and you are ready to begin operation.
If you are new to modem communications, we recommend that you read through this
manual first. If you come across terms that you don't understand, consult the glossary.
Modulation/Function Control Code
ITU-T V.42/MNP™ 2-4 Error Correction
ITU-T V.42/MNP5 Data Compression
Auto-baud DTE Rate 230.4 Kbps Maximum
TIA/EIA 578 Class 1
Full-Duplex Speakerphone Controller
Telephone Answering Machine Controller
AT Command Set
Hayes AT Commands
AT + Commands per
TIA/EIA 578 Class 1
AT # Voice Support