Table of Contents
Advertisement
+FRH=?
Table 2.15
Voice commands
Voice/Audio Responses
Shielded codes sent to DTE:
<dle>0 to <dle>9, <dle>*,<dle>#,<dle>A to <dle>D
<dle>a
<dle>b
<dle>c
<dle>d
<dle>e
<dle>f
<dle>h
<dle>o
<dle>q
<dle>s
<dle>t
<dle>u
<dle>T
<dle><etx>
Shielded <dle>
Voice/Audio Commands from DTE
<dle>p
<dle>r
<dle>E
<dle>u
<dle>d
<dle><can>
<dle><eot>
<dle><etx>
Voice/Audio commands
A - Answering in Voice/Audio Mode
D - Dial Cmd in Voice/Audio Mode
H - Hang up in Voice/Audio Mode
Z - Reset from Voice/Audio Mode
#BDR=n - Select Baud Rate (Turn off Autobaud
#BDR?
#BDR=?
#CID=n - Enable Caller ID Detection and Select
48=V.27ter 4800 bps
72=V.29 7200 bps
73=V.17 7200 bps long
74=V.17 7200 bps short
96=V.29 9600 bps
97=V.17 9600 bps long
98=V.17 9600 bps short
121=V.17 12000 bps long
122=V.17 12000 bps short
145=V.17 14400 bps long
146=V.17 14400 bps short
Note: all HDLC modes internally clip to V.21
Query range shows 3.
Description
DTMF digits detected
Answer tone (CCITT 2100 Hz)
Busy
Calling tone (1100 Hz)
Dial tone
Calling tone (1300 Hz)
Answer tone (Bell 2225 Hz)
Hook transition offhook to onhook
Overrun
Quiet
Silence
Hook transition onhook to offhook
Underrun
Timing mark
End of stream
Description
Pause
Resume
Purge DCE buffer
Increment playback volume
Decrement playback volume
Cancel
Voice bytes buffered query
Terminate
Description
A - Answering in Voice/Audio Mode
D - Dial Cmd in Voice/Audio Mode
H - Hang up in Voice/Audio Mode
Z - Reset from Voice/Audio Mode
0=enable autobaud
1,2,3,4,8,16,24,48,96=new baud rate is n*2400 bps
Query current
Query range shows 0,1,2,3,4,8,16,24,48,96
0=disable*
Advertisement
Table of Contents
