Heat Blast; Program Schedule Holds; Temporary - Aprilaire 8910W Owner's Manual

pROGRAM SCHEDUlE AND HOlDS

HEAT blAST

®
Heat Blast will raise the current room temperature 3°F
®
to 5°F based on the installer set-up, and then resume
normal operation .
press [Heat blast] to activate Heat Blast .
Note: Heat Blast button is only available if it is enabled
in the Installer Setup and the Home Comfort Control is
in Heat or Emergency Heat mode .
To cancel Heat Blast
press [CANCEl], or
[Heat blast], or the
temperature adjust
buttons.
26
pROGRAM SCHEDUlE HOlDS – TEMpORARy
TEMpORARy pROGRAM HOlD
press or to immediately adjust the temperature
when the schedule is running . This will temporarily hold
the temperature setting until the next scheduled event.
pROGRAM SCHEDUlE AND HOlDS
pROGRAM SCHEDUlE HOlDS – TEMpORARy
(CONTINUED)
press
or to adjust the end time of the hold. If
end time is not adjusted, the Temporary Hold will end at
the start of the next event.
To cancel the Temporary Hold, press [CANCEl HOlD] .
pROGRAM SCHEDUlE HOlDS – pERMANENT
pERMANENT pROGRAM HOlD
press [HOlD] to permanently hold the temperature at
its current setting while the schedule is running . This
will override the temperature settings for all events .
With the Home comfort control in Permanent Hold, the
temperature setting and fan mode can be adjusted and
will stay at that setting until the hold is cancelled .
To cancel the Permanent Hold, press [CANCEl HOlD] .
27