Changing Program Schedules; Heat Blast; Program Schedule Holds; Temporary - Aprilaire 8620W Owner's Manual

PROGRAM SCHEDUlE AND HOlDS

CHANGING PROGRAM SCHEDUlES

(CONTINUED)
Press [Next], then [FAN] to set the fan mode of the
first event .
Press [Next] to advance to the next event .
Repeat above process for each remaining event.
Press [DONE] to save the schedule for the day .
24
The thermostat will display the coPy option.
Press [COPy] to copy the schedule of the day just
programmed to any other day .
OR
Press [CANCEl] to proceed to the next day and repeat
the above process.
PROGRAM SCHEDUlE AND HOlDS

HEAT BlAST

®
Heat Blast will raise the current room temperature 3°F
®
to 5°F based on the installer set-up, and then resume
normal operation .
Press [Heat Blast] to activate Heat Blast .
Note: Heat Blast button is only available if it is enabled
in the Installer Setup and the thermostat is in Heat or
Emergency Heat mode .
To cancel Heat Blast
press [CANCEl], or
[Heat Blast], or the
temperature adjust
buttons.
PROGRAM SCHEDUlE HOlDS – TEMpORARy
TEMPORARy PROGRAM HOlD
Press or to immediately adjust the temperature
when the schedule is running . This will temporarily hold
the temperature setting until the next scheduled event .
25