Aprilaire 8910W Owner's Manual page 19

SETUp MENU
USER SySTEM SETTINGS TAblE
(CONTINUED)
User system
setting Description
Setpoint Lockout Prevents or limits changes to the heating and cooling setpoints
at the thermostat. If set to Full, no changes to the setpoints are
allowed. If set to Range, changes to the setpoint are limited by
the Max Temp Setpoint change in Lockout. Note: Only available
when the Lockout Type is set to Partial.
Max Setpoint Sets the maximum change to the heat or cool setpoint that can
Change in Lockout be made at the thermostat. Note: Only available when Setpoint
Lockout is set to Range .
Menu Lockout Prevent the Menu screen from being accessed at the thermostat.
Note: Only available if no other lockouts are enabled. If another
lockout is enabled the Menu screen is automatically locked out.
Program Format Enables the 7 day program.
Reset Service clears the change air Filter, Hvac, and Dehumidifier Service
Reminders reminders if they are active and resets the start date to the
current date. clears the change Water Panel reminder if it is
active. If the reminder is set to timed, the timer will be reset.
36
SETUp MENU
USER SySTEM SETTINGS TAblE
Factory default setting User system
(bold) and setting range setting
Disable Backlight
Full Intensity
Range
WiFi Disconnect
and Clear Settings
3°F or 1.5°C
Turn Off WiFi
1°F to 20°F (0 .5° to 10°C)
Radio
Unregister the
Disable
Thermostat
Enable
7-Day
Non-Prog
No
Yes
(CONTINUED)
Description
Set the active backlight intensity. Note: The minimum setting is
40% when constant Backlight is enabled.
Disconnects the Home Comfort Control from the router and
clears the Wi-Fi settings. Use this to set the thermostat back to
provisioning mode so it can be connected to a new Wi-Fi router.
Use to turn off the Wi-Fi radio. Wi-Fi settings will be
maintained .
Unregisters the thermostat from an Aprilaire account . Use this
when the Home comfort control needs to be registered to a new
aprilaire account. For instance, if you have purchased a home
with the thermostat already installed, this setting would allow
you to clear the previous registration so that you can register the
thermostat to your account .
Factory default setting
(bold) and setting range
100 percent
0 to 100 Percent
No
Yes
No
Yes
No
Yes
37