Select Fan Setting (On/Auto/Circ); Clean Screen; Maintenance Reminders; Screen Lockout - Aprilaire 8910W Owner's Manual

OpERATION
SElECT FAN SETTING
(ON/AUTO/CIRC)
When the fan mode is changed during a program event
it remains in that mode until the next event starts. The
fan must be programmed to FaN ON in the schedule to
run continuously through all events .
press [FAN] to select:
ON: Fan runs continuously. Use this mode for maximum
air circulation/filtering .
AUTO: Fan runs only when the heating or cooling
system is on .
CIRC: Same as aUTO, but ensures the fan is on for at
least 30 minutes per hour. Use this mode for a balance
of energy savings and air circulation/cleaning .
press [DONE] to save and exit, or [CANCEl] to exit
without saving . The Home Comfort Control will save and
exit if nothing is pressed within 10 seconds.
8

ClEAN SCREEN

press [MENU] to enter the main menu .
press [ClEAN SCREEN] to disable the touch screen
for 30 seconds for cleaning .
Note: Use a soft damp cloth to clean the screen . Use
water or household glass cleaner . Do not spray liquids
directly on the screen .
OpERATION

MAINTENANCE REMINDERS

Maintenance reminders are set up by the installer to
indicate when the equipment is due for service . If a
maintenance reminder is displayed, call your Hvac
dealer for service. They can be cleared by pressing
[MENU] to enter the main menu . press and
select YES to Service Reminders and then press [Next] .
press and to select YES for each reminder
you would like to reset . press [Next] to go to the next
reminder or [back] to go to a previous reminder . press
[DONE] to reset the selected service reminders .

SCREEN lOCKOUT

The user can disable certain features of the Home
comfort control. (See User System Setting Table on
pages 35-37 for details.) This feature can be overridden
by pressing and holding [MENU] for 7 seconds .
9