Table of Contents
Advertisement
HEAT BLAST® (IF INSTALLED)
Heat Blast® will raise the current room temperature 3°F to 5°F based on the installer set-up, and
then resume normal operation
To activate Heat Blast, select Heat Blast from the Menu, and use the Select button to set the
toggle to ON
NOTE: Heat Blast button is only available if it is enabled in the Installer Setup and the thermostat
is in Heat or Emergency Heat mode
To cancel Heat Blast, select Heat Blast from the Menu, and use the Select button to set the
toggle to OFF
PROGRAM SCHEDULE HOLDS
TEMPORARY HOLD
Press
or
to immediately adjust the temperature when the
schedule is running This will temporarily hold the temperature setting
until the next scheduled event
A temporary hold can also be set from the Hold option in the Menu
The end time of the hold can also be adjusted from here
The temporary hold can be canceled from the Hold option in the Menu,
or by adjusting the temperature back to the scheduled temperature
18
TABLE 2 – USER SYSTEM SETTINGS TABLE
Clock
Date
Display
Scale
About
Reset Reminder
HEATING
70
72
HOLD 5:00 PM
SETUP MENU
Set time
Set date
Display can be disabled during sleep for light sensitive locations
(Not available when battery only powered)
Change temperature scale from Fahrenheit to Celsius
Contains thermostat model number and software/hardware version
Reset expired service reminders
19
Advertisement
Table of Contents
