Adding New Handsets - AT&T E5927B User Manual

5.8 ghz cordless telephone/answering system with caller id/call waiting
Hide thumbs Also See for E5927B:
Table of Contents

Advertisement

Appendix

Adding new handsets

Your telephone can accommodate up to four cordless handsets. You can add new hand-
sets (E597-1, sold separately) to the E5926, E5927B, E5937B and E1937B at any time,
but each handset must be registered with the base before use.
The handset provided with your E5926 is automatically registered as Handset 1.
Additional handsets will be assigned numbers in the order they are registered (Handset
2, Handset 3, or Handset 4). You can register a maximum of 4 handsets.
The E5927B has 2 handsets automatically registered as Handset 1 and 2. You can regis-
ter two additional handsets, which will be assigned number 3 and 4.
The E5937B/E1937B has 3 handsets automatically registered as Handset 1, 2 and 3. You
can register one additional handset, which will be assigned number 4.
The E5947B has 4 pre-registered handsets, so you cannot register any additional hand-
set to it.
NOT REGISTERED
PRESS HNDST LOC
4 SEC ON BASE
HS X REGISTERED
Handset 1 Handset 2 Handset 3
Handset 4
Before using a new E597-1 handset, you must register it
with the base.
To add a new handset:
• When first purchased, all optional accessory hand-
sets show NOT REGISTERED on the screen.
• Make sure your handset battery is properly installed
and charged.
• Put the handset in a cradle which is plugged into AC
power. After a few seconds "PRESS HNDST LOC 4
SEC ON BASE" will be shown on the screen.
• Press and hold
phone base until the
seconds), then release the button.
• The handset will show PLEASE WAIT... for a while.
• The handset will show HS X REGISTERED and beep
once if registration was successful.
NOTE: You can register only one handset to the base at a time.
NOTE: If you are on a call, using the Call Log or Directory, or another
phone on the same line, you cannot register a handset.
NOTE: If the registration is not successful the display will show NOT
REGISTERED. Reset the handset by lifting the handset out of the cra-
dle and then place the handset back in the cradle. Now try the registration pro-
cess again.
43
HANDSET LOCATOR
light comes on (about 4
IN USE
on the main tele-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents