Table of Contents
Advertisement
Replacing the display
assembly
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in
After working inside your
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the display hinges with the screw holes on the
computer base.
2
Replace the screws that secure the display hinges to the computer base.
3
Route the logo-board cable through the routing guides on the display
hinge and connect the logo-board cable to the system board.
4
Route the display cable through the routing guides on the display hinge.
5
Slide the display cable into the connector on the system board and press
down the latch to secure the cable.
6
Route the antenna cables through the routing guides on the display
hinges.
7
Adhere the adhesive tapes that secure the antenna cables to the system
board.
8
Close the display and turn the computer over.
9
Connect the antenna cables to the wireless card.
The following table provides the antenna-cable color scheme for the
wireless card supported by your computer.
Connectors on the wireless card
Main (white triangle)
Auxiliary (black triangle)
10 Replace the screw that secures the wireless-card bracket to the wireless
card.
11
Turn the computer over and open the display.
Before working inside your
computer. For more safety best
computer.
Antenna-cable color
White
Black
61
Advertisement
Table of Contents
