Hand-Held Series Generators • Familiarization & Troubleshooting Guide
Section 4 • Assembly
• Install the mounting screws and tighten until the heat
shield is secure.
NOTE:
Make sure that the bent angles of the heat
shield are in contact with surfaces of the engine as
shown in figure 44.
Figure 44 — Check Heat Shield Contact And Mounting
Check to make sure that all the mounting hardware is tight
and secure.
Connecting The Wiring Harness
The control panel that is mounted in the front case half is
connected to the generator by means of two four-pin cable
connectors. The associated wires colors are identical.
• Match the wire colors of the two harness connectors
and seat each connector until it locks into place
(Figure 45).
Figure 45 — Harness Connectors
• Connect one lead of the engine run switch to the
engine ground wire.
• Connect the other wire from the engine run switch to
the connector that also houses the blue wire from the
ignition coil (Figure 46).
Figure 46 — Ground And Run Switch
35
4