Hand-Held Series Generators • Familiarization & Troubleshooting Guide
Section 4 • Assembly
Mount The Fuel Tank
Inspect the tank for the following items;
• Ensure that the fuel strainer is installed in the bottom of
the tank sump.
• Check that the rubber vibration seals are glued on the
seams of the fuel tank.
• Seat the tank in the area above the support brackets
(Figure 51).
Figure 51 — Mounting The Fuel Tank
• Connect the fuel supply hose to the tank as shown in
figure 52.
Figure 52 — Connecting The Fuel Supply Hose
Mount The Front Case Half
Before mounting the front case half, ensure that the LOS
module is oriented on its mounting as shown in figure 53.
Figure 53 — LOS Orientation
• Position the front case half close enough to the generator
unit in order to make the wiring connections to the Low
Oil Sense (LOS) module and start switch (Figure 54).
Figure 54 — Start Switch & (LOS) Wiring
37
4