Pilot Lamp
Some early units were equipped with a green pilot lamp. If
this is the case, troubleshoot the lamp using the instructions
that follow;
•• Step 1:
• Remove the three screws that secure the control panel
to the face of the generator unit.
•• Step 2:
• Remove the terminals from the lamp.
•• Step 3:
• With your VOM set to ohms, check for continuity
through the lamp (Figure 35).
Figure 35 — Checking The Pilot Lamp
3
- No continuity: Replace lamp.
Hand-Held Series Generators • Familiarization & Troubleshooting Guide
30
Troubleshooting • Section 3