Mount The Rear Case Half - Briggs & Stratton CE8070 Troubleshooting Manual

Mount The Rear Case Halve
• Position the unit as shown in figure 47.
Figure 47 — Unit Positioned For Closure
• Mount the air cleaner housing to the two studs that
extend through the carburetor (Figure 48A).
• Insert the oil breather hose into the back of the air cleaner
housing (Figure 48B).
Figure 48 — Breather Tube & Air Filter Housing
4
A
NOTE:
Make sure that the steel bushings are
installed in the housing for the air cleaner
(Figure 48A).
The rear case half is mounted on the carriage first.
Hand-Held Series Generators • Familiarization & Troubleshooting Guide
B
36
• Align the rear case half with the mounting holes in the
generator carriage.
• Refer to figure 49A & B and place the fasteners as shown.
Figure 49 — Rear Case Half Fasteners
M6-16
A
M6-20
The tank support brackets are shown in figure 50A & B.
• Insert the left-hand tank support bracket inside the case
stiffener and secure to the rear case half with a M5-16
screw with a medium pilot collar (Figure 50A).
• Mount the right hand bracket as shown in figure 50B.
Figure 50 — Fuel Tank Support Brackets
M5-16
A
Assembly • Section 4
B
M6-20
B