Briggs & Stratton CE8070 Troubleshooting Manual page 42

• Route the starter rope through its opening in the case.
• Align the front case half with the mounting points in the
generator carriage and install the fasteners (figure 55).
Figure 55 — Fastener Locations On Front Case Half
With the mounting fasteners tight, connect the wiring
harness connectors through the opening of the control
panel (Figure 56).
Figure 56 — Access To Wiring Harness
4
• Match the colors of the wires.
NOTE
: Match the color-coding of the wires to
make sure that you are making the proper
connections (Figure 57).
Hand-Held Series Generators • Familiarization & Troubleshooting Guide
Figure 57 — Wiring Harness Connections
• Install the control panel face plate (Figure 58).
Figure 58 — Install Control Panel
• Install oil service cover (Figure 59).
38
Assembly • Section 4