Table of Contents
Advertisement
Fuel System Components
1
Fuel Group:
The components that make up the Fuel group include the
items listed in Figure 6.
Figure 6 — Fuel Systems Components
Shut-Off Valve
Fuel Hose
Mounting Brackets
The items listed in Figure 7 are part of the fuel cap and are
not replaceable. If damage occurs to the fuel cap, its repair is
limited to replacement.
Figure 7 — Fuel Cap Assembly
Fuel Cap Assembly
Tank Sump Filter
Fuel Strainer
Spill Well
Hand-Held Series Generators • Familiarization & Troubleshooting Guide
GENERAL SERVICE INFORMATION
Work Area
Good lighting and an elevated table will help you gain access
to all of the mounting hardware and accessories of the hand-
held generator. Certainly, larger is better but a good
minimum sized table would be 20in. by 30in. If casters are
applied to the legs of the table, be sure they are secure and
sturdy enough to support not only the generator but also
the work being performed.
Hand Tools
A minimum collection of standard mechanic's hand tools
should include:
· 3/8" drive socket set (SAE)
· 3/8" drive socket set (Metric)
· A 3/8" drive ratchet
Tank
· Short, medium and long 3/8" drive extensions
· A large (heavy) "soft" mallet
· A common screwdriver (medium length)
· A Phillips screwdriver (medium length)
· A Phillips screwdriver (short- "stubby")
· A large (heavy duty) screwdriver suitable for mild prying
Special Tools
Electronic Measuring Equipment:
The measuring equipment used in troubleshooting should be
of industrial quality and have the sensitivity to measure
electronic values to the third decimal. Its accuracy should be
within acceptable tolerances should have the ability to
measure capacitance.
12
Introduction • Section 1
- Quick Links:
- Resistance Values
Hide quick links:
Advertisement
Table of Contents
