Mounting The Rotor & Stator - Briggs & Stratton CE8070 Troubleshooting Manual

Hand-Held Series Generators • Familiarization & Troubleshooting Guide
Section 4 • Assembly
Mounting The Rotor & Stator
Position the generator/base plate assembly as shown in
figure 36, before mounting the stator assembly.
Figure 36 — Generator / Base Plate Assembly
• Mount the rotor on the tapered shaft of the engine
(Figure 37).
Figure 37 — Mount The Rotor
NOTE: The rotor is not timed in any way.
• Position the stator and the rear bearing carrier over
the rotor and align the feet with the mounting holes in
the base plate (Figure 38).
Figure 38 — Positioning The Stator
• Install the bolts but do not tighten yet.
Make sure the stator is seated in the machined lands of its
cradle as shown in figure 39A and 39B.
Figure 39 — Seating The Statot Assembly
A
With the stator properly seated in the machined lands of its
cradle:
33
B
4