Bagging The Clippings; Installing The Grass Bag; Removing The Grass Bag - Toro 20360 Operator's Manual

Note: Move the cutting height levers forward to raise the mower; move
the cutting height levers rearward to lower the mower.
1. Front cutting height lever (2)
Note: The cutting height settings are 1 inch (25 mm); 1-1/2 inch (38
mm); 2 inches (51 mm); 2-1/2 inches (64 mm); 3 inches (76 mm); 3-1/2
inches (89 mm); and 4 inches (102 mm).
Figure 8
2. Rear cutting height lever (2)

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings
from the lawn.
WARNING
A worn grass bag could allow small stones and other similar
debris to be thrown in the operator's or bystander's direction
and result in serious personal injury or death to the operator or
bystanders.
Check the grass bag frequently. If it is damaged, replace it with an
identical Toro replacement bag only.

Installing the Grass Bag

1. Lift up the rear deflector (Figure 9).
1. Rear deflector
2. Inset the grass bag handle onto the notches on the handle
brackets (Figure 10).

Removing the Grass Bag

1. Lift up the rear deflector.
2. Lift the grass bag handle out from the notches on the handle
brackets and remove the bag from the mower.
3. Close the rear deflector.
7
Figure 9
Figure 10