Unfolding The Handle; No Parts Required; Charging The Battery - Toro 20360 Operator's Manual

Setup
Note: Determine the left and right sides of the mower by standing
in the operating position.
NOTICE! Do not insert the key into the plug receptacle until you
have assembled the mower.
1

Unfolding the Handle

No Parts Required

CAUTION
Folding or unfolding the handle improperly can damage the
cables, causing an unsafe operating condition.
•
Do not damage the cables when folding or unfolding the
handle.
•
If a cable is damaged, contact an Authorized Service Dealer.
1. Loosen the handle knobs (Figure 1).
1. Handle knob (2)
2. Move the handle to the operating position (Figure 2).
Figure 1
3. Tighten the handle knobs firmly by hand.
2

Charging the Battery

No Parts Required
WARNING
Contact with water while charging the battery or operating the
mower can cause an electric shock, leading to personal injury or
death.
Do not handle the charger plug or the mower with wet hands or
while standing in water.
NOTICE! For best performance, use only a Toro 36-volt charger
(part no. 119-0269).
It takes approximately 12 to 16 hours to charge a fully discharged
battery. Fully charge the battery before the first mowing of the season,
after every use, and before off-season storage. Failing to charge the
battery after every use shortens the battery life. Charge the battery
even if you run the mower for only a few minutes.
Note: The battery is charged at the factory. However, before using the
mower for the first time, charge the battery and ensure that it has a full
charge before operating.
To charge the battery, do the following:
NOTICE! Always charge the battery in a dry area protected
from the weather. Also, keep the mower away from water and
flammable substances.
1. If the key is in the plug receptacle, remove it (Figure 3).
4
Figure 2