Toro 20360 Operator's Manual page 5

1. Key (remove it before charging the battery)
WARNING
The battery charger cord can be damaged and could cause a
shock or fire.
Thoroughly inspect the battery charger cord before charging
the unit. If the cord is damaged, do not charge the battery.
Replace or repair a damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
2. Insert the charger cord into the charging plug receptacle (Figure 4),
and connect the other end to a standard 120-volt household outlet.
1. Charging plug receptacle
Note: Your battery charger has a two-color LED display that
indicates the following states of charging:
—A red light indicates that the charger is charging the battery.
—A green light indicates that the battery is fully charged; the
charger is trickle-charging the battery to maintain the battery
charge.
3. Charge the battery for at least 16 hours.
4. Unplug the charger cord from the standard outlet and the charging
plug receptacle on the mower.
Figure 3
Figure 4
Note: Do not unplug the charger cord by pulling on it. To unplug
the cord, grasp the plug, not the cord.
NOTICE! This mower has a battery charger that checks the
charge state of the battery and charges the battery only when
necessary. Toro recommends that you unplug the charger
after 24 hours of charging, though you may leave the charger
plugged into the mower longer without harming the system.
During the non-mowing season, you can unplug and store the
mower for up to three months if the battery is fully charged
and the mower is stored in a cold, dry place.
5