Table of Contents
Advertisement
Operation
Each time before you use the mower, ensure that the control bar
operates properly. When you release the control bar, the motor and the
blade should stop. If they do not, contact an Authorized Service Dealer.
Using the Key
The mower only operates when the key is fully seated in the plug
receptacle (Figure 5). To prevent accidental starting or unauthorized
use of the mower, always remove the key from the plug receptacle
whenever you leave the mower unattended. Store the key out of the
reach of children.
1. Key
Starting the Mower
1.
Push the mower onto a flat concrete or asphalt surface.
Note: Starting the mower in thick grass could cause the mower
to clog.
2.
Insert the key fully into the plug receptacle (Figure 5).
3.
Insert a couple of fingers into the opening of the starter and push
the control lever toward the handle (Figure 6).
1. Control lever
4.
Squeeze the control lever to the handle.
Figure 5
Figure 6
Note: Keep the mower running when turning the mower. Turning
the mower off when making a turn does not save battery energy.
Stopping the Mower
1.
Release the control lever.
WARNING
When the key is in the plug receptacle, the mower is
operational. Someone could accidentally start the mower and
seriously injure you or other bystanders.
Always remove the key from the plug receptacle when leaving
the mower unattended, even for a short period of time.
2.
Remove the key from the plug receptacle if the mower will be
unattended for any period of time. Store the key in a place out
of the reach of children.
3.
Charge the battery.
NOTICE! Always charge the battery immediately after using
the mower. If you do not charge the battery after each use,
you will shorten the battery life. See Charging the Battery.
Adjusting the Cutting Height
WARNING
Adjusting the cutting height may bring you into contact with the
moving blade, causing serious injury.
•
Stop the engine and wait for all moving parts to stop.
•
Do not put your fingers under the housing when adjusting
the cutting height.
Adjust the cutting height as desired. Set all four wheels to the same
height (Figure 8).
6
Figure 7
Hide quick links:
Advertisement
Table of Contents
