Table of Contents
Advertisement
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it and install the side-discharge deflector before bagging
the clippings; refer to
Removing the Side-Discharge Chute (page
Installing the Grass Bag
1.
Raise and hold up the rear deflector (A of
2.
Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
3.
Install the bag rod into the notches at the base of the handle, and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
4.
Lower the rear deflector until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in
Figure
Figure
18).
Figure 18
Installing the Grass Bag (page
18).
18).
Figure
18).
17).
17
g235892
Advertisement
Table of Contents
