Bagging The Clippings; Side-Discharging The Clippings - Toro TimeMaster 21815 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the mower, remove it before bagging the clippings; refer to
Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
3. Install the bag rod into the notches at the base of the handle and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
4. Lower the rear deflector until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the
rear-discharge plug; refer to
(page 19) before side-discharging the clippings.
Important:
Ensure that the rear-discharge plug is
in place before you recycle the clippings
23).
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute (Figure
20).
Figure
Figure 24).
Installing the Grass Bag (page
Removing the Grass Bag
(Figure
25).
24).
Figure 24)
Figure 24
19).
19
Removing the
Figure 25
g244854
g235646