Completing The Installation - IBM eServer 240 xSeries User Reference Manual

Completing the installation

To complete your installation, you must reinstall the cover and reconnect all the
cables that you disconnected in "Preparing to install options" on page 46, and, for
certain options, run the Configuration/Setup Utility program. Follow the instructions
in this section.
Completing the tower model installation
To complete the installation for the tower model:
If you have a tower model, continue with "Completing the tower model
installation."
If you have a rack model, go to "Completing the rack model installation" on
page 88.
1. Install the left-side cover, if it was removed.
1 Slots
2 Left-side cover
a. Align the left-side cover 2 with the left side of the server, about 25 mm
(1 inch) from the front of the server; place the bottom of the left-side cover
on the bottom rail of the left-side side of the chassis.
b. Insert the tabs at the top of the cover into the slots
server side.
c. Hold the cover against the server and slide the cover toward the front of
the server until the cover clicks into place.
C P
U
V R
M
M E
M O
P C R Y H D
I B D
U S
A
B
N M
P O I
W
E R S M
I
S U S E
1 P P R V
LY B U IC
2 S E
P R
3 O C
FA N O E S
N S O
N R
R E
D U
1 N D
A N
2 T
3
T E
M P
E R
AT
U R
E
1 at the top of the
Chapter 4. Installing options
85