IBM eServer 240 xSeries User Reference Manual page 82

To install a non-hot-swap drive in one of the non-hot-swap bays:
1. Turn off the server and peripheral devices (see "Preparing to install options" on
2. Remove the trim bezel. (See "Removing the trim bezel" on page 51.)
3. Remove the filler panel 2 from the bay opening by pulling the filler panel
4. Touch the static-protective bag containing the drive to any unpainted metal
5. Set any jumpers or switches on the drive according to the documentation that
6. Install rails on the drive.
7. Place the drive so that the slide rails engage in the bay guide rails. Push the
8. If you have not already done so, install an optional SCSI adapter. (See to
9. Connect one of the connectors on the SCSI cable for the non-hot-swap drive
10. Connect a power cable to the back of the drive. Power cables for
11. If you are installing another non-hot-swap drive, do so at this time. Otherwise,
12. If you have other options to install or remove, do so now; otherwise, go to
72
IBM xSeries User's Reference
page 46) and then remove the cover. See "Removing the left-side cover
(tower model)" on page 48 or "Removing the cover (rack model)" on page 49.
away from the server. You do not need the filler panel when you have a drive
installed in the bay.
surface on the server; then, remove the drive from the bag and place it on a
static-protective surface.
comes with the drive.
If you are installing a standard-size drive:
a. Pull the blue slide rails 3 off the back of the filler panel.
b. Clip the rails onto the sides of the drive.
If you are installing a digital linear tape (DLT) backup drive 1 , the slide
rails 4 and screws are included in the box with your server
documentation.
drive into the bay until it clicks into place.
"Working with adapters" on page 53 for information about installing an
adapter.) See "SCSI drives" on page 69 for information about optional SCSI
adapters, installation of drives in the non-hot-swap bays, and the 16-bit 2-drop
SCSI cable that is provided for use with optional SCSI adapters.
bays to the back of the drive 1 .
non-hot-swap drives come installed in your server. The connectors are keyed
and can be inserted only one way.
continue with the next step.
"Completing the installation" on page 85.