IBM eServer 240 xSeries User Reference Manual page 131

POST message Description
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the server without the
adapters, reinstall each adapter one at a time and retest after each is reinstalled.
When an adapter fails, replace it.
If the problem persists, have the system serviced.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the server without the
adapters, reinstall each adapter one at a time and retest after each is reinstalled.
When an adapter fails, replace it.
If the problem persists, have the system serviced.
01295085 The ECC checking hardware test failed.
Action: Have the system serviced.
01298001 No update data is available for processor 1.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server. Refer to Chapter 7, "Getting help, service, and information"
on page 161 for information about obtaining updates.
01298002 No update data is available for processor 2.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server. Refer to Chapter 7, "Getting help, service, and information"
on page 161 for information about obtaining updates.
01298101 The update data for processor 1 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server. Refer to Chapter 7, "Getting help, service, and information"
on page 161 for information about obtaining updates.
01298102 The update data for processor 2 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server. Refer to Chapter 7, "Getting help, service, and information"
on page 161 for information about obtaining updates.
01298200 Microprocessor speed mismatch
Action: The microprocessors installed do not run at the same speed; install
microprocessors with identical speeds.
A hard disk drive error occurred.
I9990301
Action: Have the system serviced.
POST could not find an operating system.
I9990305
Action: Install an operating system. If you have already installed the operating
system, check the drive startup sequence (see "Start Options" on page 27). If the
drive sequence is correct, run the diagnostic tests to verify that the hard disk drive is
functioning correctly. If there is a problem with the hard disk drive (such as a bad
sector), you might have to reinstall the operating system.
If you cannot reinstall the operating system, have the system serviced.
AC power has been restored.
I9990650
Action: No action is required. This message appears each time ac power is
restored to the server after an ac power loss.
Other Numbers POST found an error.
Action: Follow the instructions on the screen.
Chapter 6. Solving problems
121