IBM eServer 240 xSeries User Reference Manual page 130

POST message
00180100
00180200
00180300
00180400
00180500
00180600
00180700
120
IBM xSeries User's Reference
Description
A PCI adapter has requested memory resources that are not available.
Action:
1. Make sure that the PCI adapter and all other adapters are set correctly in the
Configuration/Setup Utility program. If the memory resource settings are not
correct, change the settings. For information about using the
Configuration/Setup Utility program, see "Using the Configuration/Setup Utility
main menu" on page 21.
2. If all memory resources are being used, you might need to remove an adapter
to make memory available to the PCI adapter. For information about removing
adapters, see "Working with adapters" on page 53. Disabling the adapter BIOS
on the adapter might correct the error. Refer to the documentation provided
with the adapter.
A PCI adapter has requested an I/O address that is not available, or the PCI
adapter might be defective.
Action:
1. Make sure that the I/O address for the PCI adapter and all other adapters are
set correctly in the Configuration/Setup Utility program. For information about
using the Configuration/Setup Utility program, see "Using the
Configuration/Setup Utility main menu" on page 21.
2. If the I/O port resource settings are correct, the PCI adapter might be defective.
Have the system serviced.
A PCI adapter has requested a memory address that is not available, or the PCI
adapter might be defective.
Action:
1. Make sure that the memory address for all other adapters are set correctly in
the Configuration/Setup Utility program. If the memory resource settings are not
correct, change the settings. For information about using the
Configuration/Setup Utility program, see "Using the Configuration/Setup Utility
main menu" on page 21.
2. If the memory resource settings are correct, the PCI adapter might be defective.
Have the system serviced.
A PCI adapter has requested a memory address that is not available.
Action: If all memory addresses are being used, you might need to remove an
adapter to make memory address space available to the PCI adapter. For
information about removing adapters, see "Working with adapters" on page 53.
Disabling the adapter BIOS on the adapter might correct the error. Refer to the
documentation provided with the adapter.
A PCI adapter ROM error occurred.
Action: Remove the PCI adapters. If you can start the server without the
adapters, reinstall each adapter one at a time and retest after each is reinstalled.
When an adapter fails, replace it.
If you cannot isolate and correct the problem, have the system serviced.
A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory
below 1 MB.
Action: Remove the PCI adapter that has the PCI bridge. If you can start the
server without the adapter, reinstall and retest the adapter. If the adapter fails,
replace it.
If you cannot isolate and correct the problem, have the system serviced.
xxxxyyyy Planar PCI device does not respond.
where xxxx is the PCI vendor ID and yyyy is the PCI device ID.
Action: Have the system serviced.