IBM eServer 240 xSeries User Reference Manual page 151

UNIX messages
This section contains the error messages for the SCO UNIX LLI device driver.
pnt0-2
Explanation: The device driver cannot locate the Ethernet controller on the PCI bus.
Action: Run the NETCONFIG program to search for another Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See "PCI Slot/Device Information" on page 28.)
If the Ethernet controller is enabled, go to "Diagnostic programs" on page 110 to run the diagnostic
programs.
pnt0-6
Explanation: On a SunSoft Solaris system, this message indicates that the system is out of Streams
memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
Modify the interrupt request (IRQ) settings in the Configuration/Setup Utility program, or run the
NETCONFIG program to match the hardware settings.
pnt0-7
Explanation: The system is out of Streams memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
pnt0-11
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See "PCI Slot/Device Information" on page 28.)
If the Ethernet controller is enabled, go to "Diagnostic programs" on page 110 to run the diagnostic
programs.
pnt0-12
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See "PCI Slot/Device Information" on page 28.)
If the Ethernet controller is enabled, go to "Diagnostic programs" on page 110 to run the diagnostic
programs.
pnt0-13
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts with
other devices in the server.
Action: Modify your hardware settings.
Run the NETCONFIG program to match the hardware settings.
pnt0-14
Explanation: The SunSoft Solaris device driver cannot find any Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See "PCI Slot/Device Information" on page 28.)
If the Ethernet controller is enabled, go to "Diagnostic programs" on page 110 to run the diagnostic
programs.
pnt0-15
Explanation: The SunSoft Solaris device driver cannot find any more Ethernet controllers.
Action: Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are present or replace the
Ethernet adapter that fails to respond. If the problem persists, go to "Diagnostic programs" on page 110
to run the diagnostic programs.
PCI search specified, PCI device not found!
Cannot allocate memory for the adapter during an interrupt. Please check your
Streams parameters.
Cannot allocate memory for the adapter during reset. Please check your Streams
parameters.
Device not found!
Device failed checksum test!
add_intr_handler failed! Interrupts already enabled.
Cannot locate hardware.
No more devices to open.
Chapter 6. Solving problems
141