Canon iR5055 Series Service Manual page 370

Chapter 11
The table below shows the setting methods for each combination of login method and Start/Stop.
Start Password Authentication
Stop Password Authentication
When only RLS Authentication is enabled, there may be a case you cannot login to device for the following reasons.
- Authentication server down
- Disconnection with authentication server due to network failure
In these cases, boot the device as MEAP SAFE mode from device service mode.
By booting the device as MEAP SAFE mode, login to SMS becomes available as Default Authentication is enabled. After login to SMS, set RLS Authentication
as Started, return the device to normal mode, and then login by RLS Authentication.
Setting for login by Password Authentication
1) In order to make a setting for login by Password Authentication, you need to login by RLS Authentication. Therefore, login by RLS Authentication.
Login screen (In case authentication method is SSO)
2) Select 'System Management' tab > 'Utility' tab > 'Application Management Function' tab.
3) In order to enable login by Password Authentication, tick SMS Installer Service (Password Authentication) radio button and then click [Start]. On the other hand,
in order to disable login by Password Authentication, clear the tick of SMS Installer Service (Password Authentication) radio button and click [Stop].
11-6
T-11-9
Start RLS Authentication
Login available with either method
Login available only with RLS Authentication
F-11-4
F-11-5
Stop RLS Authentication
Login available only with Password Authentication
Setting unavailable