- 2 screws [2]
2) Store the following parts:
- Drum rotational tool [1]: store it along with the collecting toner cap to
the hole of the pullout grip at the top of the collecting toner case [2].
- Grip: insert to the grip storing area [3]
[3]
If pulling out the pullout grip fully, it makes the drum rotational tool and
the cap fail to be inserted.
It is easy to insert them if pulling the pullout grip at moderate position
shown in the figure below.
[2]
[1]
F-2-67
[1]
[2]
F-2-68
3) Attach the lower rear right cover removed in the step 1).
<Attaching of the grip cover>
1) Attach the grip cover (small) [1] to the latch face cover [2].
[2]
2) Attach the 3 grip covers (large) [1] and the cover [2] that was attached in
the step 1).
[1]
<Attaching of the service book case>
1) Peel off the two-sided tape located at the back of the service book case [1]
to attach to the bottom plate of the host machine.
Chapter 2
[1]
F-2-69
[1]
[2]
F-2-70
2-17