Customizing A Dial-Up Connection To An Alarm Station - Honeywell rapid eye System Administrator Manual

Table 11–4 Area Code Matching, for Site and Alarm Station
Multi-Media Unit
enter: 773 (Chicago)
enter: 773 (Chicago)
enter: 701 (Fargo)
(Fargo) code not entered
* One of the area codes for Chicago is: 773.

Customizing a Dial-Up Connection to an Alarm Station

Preparation
Before customizing a dial-up connection, check your alarm station definition, as explained in
up Connection to an Alarm
Fig. 11–8. Irregular Use of Area Codes when Units Are Calling an Alarm Station.
No need to customize... most times
You do not need to customize a long distance code when a Multi-Media unit uses regular long
distance. One or many such sites can call-in alarms to the same alarm station without concern.
By default, Multi makes local calls when long distance codes match. You can add a long distance
or toll-free code, site-by-site as needed, in the Update Station to Call in Case of Alarms box. See
figure 11–9,
Document 800-02325 Rev A
07/08
Alarm Station (Chicago*)
enter 773 (Chicago)
code not entered
enter: 773 (Chicago)
(Chicago) code not entered
Station.
below and section Customizing a Dial-Up Connection to an Alarm
System Administrator Guide
Match Result
yes OK: 555-1212
no OK, local: 555-1212
no OK: 1 773 555-1212
yes (?) error; a long distance
call is needed.
Station, p. 48.
Dial-
217