Appendix: Lc-Series Controller And Tec-Eye Architecture - Bard W48A2PQ Installation And Service Instructions Manual

APPENDIX: LC-SERIES CONTROLLER AND
TEC-EYE ARCHITECTURE
CAUTION: The Bard 575 volt wall mount unit system has been pre-programmed with what is widely considered to be
the best settings for efficiency and operation. Any changes to internal programming through the LC-Series controller
or the TEC-EYE not covered within this manual may cause the systems to operate improperly, cause internal damage
to the HVAC units, cause the shelter to overheat or other very serious consequences. Although complete controller
programming architecture for both the LC-Controller and TEC-EYE has been provided, going outside the boundaries
of what has been covered in this manual is not recommended.
Screen Menu Item
1 MAIN STATUS SCREEN
Date and Time
Zone 1 Temp
Zone 2 Temp
Zone 3 Temp
Zone 1 Humidity
Zone 2 Humidity
Zone 3 Humidity
Status
2-4 Humidifier Screens
Humidifier 1 Request
Production
Current
Conductivity
5-16 Unit Screens
Return Air Temperature
Mixed Air Temperature
Outdoor Air Temperature
Outdoor Air Humidity
Blower
Damper
17-28 Last hour tracking
Free Cooling Run Minutes
and Starts
Cooling 1 Run Minutes and
Starts
Cooling 2 Run Minutes and
Starts
Heating 1 Run Minutes and
Starts
Heating 2 Run Minutes and
Starts
Manual 2100-642
Page 64 of 82
Range Default Value
Degrees
Degrees
Degrees
% RH
% RH
% RH
Comfort Mode/
Normal/Off
0-100%
Kg/Hr.
Amps
us/cm
Degrees
Degrees
Degrees
Degrees
On/Off
% Open
Minutes/Starts
Minutes/Starts
Minutes/Starts
Minutes/Starts
Description
Displays current date and time
Disaplays zone temp
Display zone temp if enabled
Display zone temp if enabled
Display zone humidity if enabled
Display zone humidity if enabled
Display zone humidity if enabled
Current mode of operation
Dependant on number of units enabled
If humidifiers are enabled
If humidifiers are enabled
If humidifiers are enabled
If humidifiers are enabled
Dependant on number of units enabled
Current return air temp for unit address
displayed
Current mixed air temp for unit address
displayed
Current outdoor air temp for unit
address displayed
Current outdoor air humidity for unit
address displayed
Current blower status for unit address
displayed
Current damper status for unit address
displayed
Dependant on number of units enabled
If applicable
Number of compressor run minutes and
starts
If applicable
Number of heater run minutes and
starts