Table of Contents
Advertisement
Num-
Symptom
ber
29
Stapling can-
not be speci-
fied.
30
Stapling is
not per-
formed as
specified.
Possible Cause
The optional finisher
is not installed, or
the finisher is not
selected on the
Device Options Set-
ting tab.
• The paper size
setting is smaller
than the standard
size, such as for
postcards or enve-
lopes.
• Booklet binding or
overhead projector
transparency inter-
leaving is speci-
fied.
Thick paper or over-
head projector trans-
parencies are used.
• The number of
copies exceeds 50
pages.
• Paper with differ-
ent sizes are com-
bined.
Stapling will be par-
allel to the paper
feed direction.
T-10
Remedy
Check that the fin-
In order to specify sta-
isher is installed,
pling, the optional fin-
and check the
isher must be installed. In
selected settings
addition, stapling cannot
on the Device
be specified unless the
Options Setting
finisher is selected on the
tab.
Device Options Setting
tab.
Check the paper
size setting, and
check if the "Book-
let Creation" set-
ting or the "OHP
Interleaving" func-
tion is selected.
Check the paper
type.
Check the number
of copies and the
paper size.
Check the direc-
Staples cannot be
tion that the paper
punched parallel to the
is loaded.
feeding direction. For
example, when printing a
landscape document on
A4 paper in the portrait
orientation, staples can-
not be punched at the top
of the page.
The stapling position for a
single staple, as a rule, is
in the upper-left corner of
paper loaded in the land-
scape orientation.
Description
Advertisement
Table of Contents
