Table of Contents
Advertisement
Num-
Symptom
ber
7
Data was
The specifically
sent, but
designed printer
could not be
driver was not used.
printed, or
The correct cable is
printing did
not used, or the
not begin for
cable is not correctly
a long time.
connected.
Data transmission
was not finished.
The print port for the
driver is incorrect.
This unit is not
selected as the
default printer.
The print queue is
temporarily paused
or is offline.
8
No paper is
There is no paper, or
fed out.
there is no paper of
the specified size.
Mailbox printing has
been specified.
9
Paper of the
The paper drawer
specified
has been specified.
size is
loaded, but
printing is not
performed.
Possible Cause
Use the specifi-
cally designed
printer driver.
Check the cable.
Wait a little while
longer.
Check the print
port on the Ports
tab (Windows
2000/XP/NT 4.0)
or General tab
(Windows 98/Me)
Select this unit as
the default printer.
Continue the
queue or set the
copier online.
If a message
appears, indicating
that the paper
must be replen-
ished, load the
paper.
T-3
Remedy
Description
If the print data cannot be
received correctly, stop
printing.
Since this unit is a page
printer, if the data for one
page is incomplete, print-
ing will not begin. In addi-
tion, if a large amount of
data is being sent in the
graphics mode, data
transmission takes some
time.
Paper is not fed out if
mailbox printing has been
specified.
When specifying a paper
drawer, depending on the
settings for the selected
paper drawer, do not
select paper in a drawer
with different settings.
Advertisement
Table of Contents
