Table of Contents
Advertisement
Mode
355
Bit:
Bit
Feature
7 – 6
Switching between 10 Mbps and
100 Mbps:
Specifies the communication speed
for the LAN adapter.
(network function)
5
Switching between full duplex and
half duplex:
Specifies the packet transmission
when connected to a switch.
(network function)
4
Automatic acquisition of IP address
3 – 0
✽1 With "Fixed at 100 Mbps" and "Fixed at 10 Mbps", if the communication speed is not
correctly set, communication will not be performed correctly. Check the communication
speed of the recipient, and make sure that the correct setting is selected.
Note: Features marked with asterisks can be specified by the user. ✽ indicates screen settings.
Factory Setting
7
6
5
4
3
2
1
0 0 1 1 0 0 0 0
Logical Value
0
1
Bit 7-6:
00
01
10
✽
11
Full
Half
duplex
duplex
✽
No
Yes
✽
Fixed
S-6
0
HEX:20
Description
Auto-negotiate
• Auto-negotiate setting:
Automatically distinguishes
Fixed at 100 Mbps
between 10BASE-T and
Fixed at 10 Mbps
100BASE-TX, and deter-
Do not specify this
mines the communication
setting.
speed.
• Fixed at 100 Mbps:
Specifies a connection
fixed at 100BASE-TX.
• Fixed at 10 Mbps:
Specifies a connection
fixed at 10BASE-T.
• The settings are applied
after the copier is turned
off, then on again.
Available when bits 7 and 6 of mode 355 are set
to "Fixed at 100 Mbps" or "Fixed at 10 Mbps".
• Full duplex setting:
Transmission and reception of packets are per-
formed simultaneously.
• Half duplex setting:
Transmission and reception of packets are per-
formed separately.
The settings are applied after the copier is turned
off, then on again.
DHCP
Do not change these settings.
Advertisement
Table of Contents
