Warning Messages - Yamaha Aventage RX-A1050 Owner's Manual

1 2 3 4 5 6 7 8 9 10 11

Warning messages

If a warning message is displayed after the measurement, you can still save the measurement results by following on-screen instructions.
However, we recommend you perform YPAO again in order to use the unit with the optimal speaker settings.
Warning message Cause
A speaker cable may be connected with the reverse polarity
W-1:Out of Phase
(+/-).
A speaker is placed more than 24 m (80 ft) from the listening
W-2:Over Distance
position.
There are significant volume differences between the
W-3:Level Error
speakers.
Remedy
Select "Wiring" in "Result" (p.44) and check the cable connections (+/-) of the speaker identified by
"Reverse".
If the speaker is connected incorrectly:
Turn off the unit and then reconnect the speaker cable.
If the speaker is connected correctly:
Depending on the type of speakers or room environment, this message may appear even if the speakers are
connected correctly. In this case, you can ignore the message.
Select "Distance" in "Result" (p.44) and move the speaker identified by ">24.00m (>80.0ft)" within 24 m
(80 ft) of the listening position.
Select "Level" in "Result" (p.44) and check the speaker identified by "Over ±10.0dB", then check the usage
environment and cable connections (+/-) of each speaker, and the volume of the subwoofer. We recommend
using the same speakers or speakers with specifications that are as similar as possible.
46
En