Warning Messages - Yamaha RXA670 Owner's Manual

Warning messages

If a warning message is displayed after the measurement, you can still save the
measurement results by following on-screen instructions.
However, we recommend you perform YPAO again in order to use the unit with the
optimal speaker settings.
Warning mnssagn
TV screen
Problem speaker (blinks)
LINK MASTER STEREO TUNED ZONE
2 A
SLEEP PARTY
OUT 2 -R es
Hi ENHANCER YPAO VOL. A- DRC
ECO
W-1:PHASE
Front display
n
Procedure to handle warnings
1
Check the content of warning message and press ENTER.
2
Use the cursor keys (e/r) to select the desired operation.
To save the measurement results:
1
Select "SAVE" and press ENTER.
To discard the measurement result:
1
Select "CANCEL" and press ENTER.
3
Disconnect the YPAO microphone from the unit.
3 B
VOL. MUTE VIRTUAL
FPL FPR
SL SW SR
SBL SB SBR
Warning message Cause
A speaker cable may be
W-1:Out of Phase
connected with the reverse
(W-1:PHASE)
polarity (+/-).
A speaker is placed more
W-2:Over Distance
than 24 m (80 ft) from the
(W-2:DISTANCE)
listening position.
There are significant volume
W-3:Level Error
differences between the
(W-3:LEVEL)
speakers.
Note
Texts in parentheses denote indicators on the front display.
38
En
Remedy
Check the cable connections (+/-) of the
problem speaker.
If the speaker is connected incorrectly:
Turn off the unit, reconnect the speaker
cable.
If the speaker is connected correctly:
Depending on the type of speakers or
room environment, this message may
appear even if the speakers are
connected correctly. In this case, you
can ignore the message.
Exit YPAO, turn off the unit, and place the
problem speaker within 24 m (80 ft) of the
listening position.
Check the usage environment and cable
connections (+/-) of each speaker, and
the volume of the subwoofer. If there is
any problem, exit YPAO, turn off the unit,
and then reconnect speaker cable or
correct the speaker positions. We
recommend using the same speakers or
speakers with specifications that are as
similar as possible.