Error And Warning Messages - Yamaha RN1000ASL User Manual

PREPARATION > Automatic adjustment of speaker settings (YPAO)

Error and warning messages

When error or warning messages are displayed, resolve the cause based on the following table and measure
again.
n
Error Messages
Error Messages
E-1:Noisy
E-2:No Signal
E-3:No MIC
E-4:User Cancel
E-5:Headphone pluged
E-10:Internal Err.
E-20:No Speakers
E-21:Control Knob
E-22:Pure Direct
NOTE
To exit YPAO in order to resolve the cause, press the ENTER key and then use the cursor keys (q/w) to select "Cancel" and press
(
the ENTER key.
To measure again, press the ENTER key and then use the cursor keys (q/w) to select "Retry" and press the ENTER key.
(
n
Warning Messages
Even when a warning message is displayed, the measurement results can still be saved. However, to get the
best speaker settings, we recommend resolving the cause and running the measurements again.
Measure again after making the room quiet.
Plug the YPAO microphone securely into the YPAO MIC jack and measure again.
If this error occurs frequently, contact the outlet where you bought this
product, or the authorized Yamaha service center.
Plug the YPAO microphone securely into the YPAO MIC jack and measure again.
Depending on your purpose, measure again or close YPAO.
Unplug the headphones and then measure again.
After finishing YPAO, turn this product OFF and back ON. If this error occurs
frequently, contact the outlet where you bought this product, or the authorized
Yamaha service center.
Select the speakers to use (A, B, A+B or Off) and then measure again. If the same
error message appears again, exit YPAO, turn OFF this product, and check the
speaker and/or PRE OUT jack connections. If using an external amp, check its
connections and power.
Make sure the controls on the front panel, BASS, TREBLE, BALANCE and
LOUDNESS, are in the center or FLAT positions, and then measure again.
Turn PURE DIRECT on the front panel OFF (indicator not lit) and then measure
again.
49
[Search tag]#Q01 YPAO Error and Warning
Solution