Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Speaker Imp.) - Yamaha Aventage RX-A1050 Owner's Manual

Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
STRAIGHT
PROGRAM
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.

ADVANCED SETUP menu items

• Default settings are underlined.
Item Function
SPEAKER IMP. Changes the speaker impedance setting.
REMOTE SENSOR Turns on/off of the remote control sensor on the main unit.
REMOTE CON AMP Selects the unit's remote control ID.
(Asia and General models only)
TUNER FRQ STEP
Changes the FM/AM tuning frequency setting.
TV FORMAT Switches the video signal type.
MONITOR CHECK Removes the limitation on HDMI video output.
4K MODE Selects the HDMI 4K (60 Hz/50 Hz) signal format.
Creates backup of the settings of the unit, or recovers the settings
RECOV./BACKUP
from the backup.
INITIALIZE Restores the default settings.
FIRM UPDATE Updates the firmware.
VERSION Checks the version of firmware currently installed on the unit.

Changing the speaker impedance setting (SPEAKER IMP.)

¡SPEAKER¡IMP.
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
¡¡¡¡¡¡¡¡¡8¬MIN
ZONE ZONE ZONE
IN OUT 1 OUT 2 2 3 4
ENHANCER SLEEP
HD 3
Change the unit's speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Select this option when you connect 6-ohm speakers to the unit. You
6  MIN
can also use 4-ohm speakers as the front speakers.
Select this option when you connect 8-ohm or higher speakers to the
8  MIN
unit.
131
En
MUTE VOLUME
ADAPTIVE DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
Page
131
132
132
132
132
133
133
133
133
134
134