External Media Sources - Datamax h-class h-8308p Operator's Manual

3.1.2

External Media Sources

A. Place the media supply (box or roll) parallel to and in-line with the Rear Media Loading
Slot or Bottom Media Loading Slot, in a position that will not cause the media to twist or
turn as it feeds from the source.

If loading reflective media, be sure that the material enters the printer with
the black marks facing down.
B. Route the media into the printer through the Rear Media Loading Slot or Bottom Media
Loading Slot, and if equipped over the Rewind Hub.
C. Route the media under the Media Guide Extrusion then out of the printer, as shown in
the previous section.
D. Rotate the Media Guide into the DOWN position and then slide the guide inward until it
rests lightly against the edge of the media, as shown in the previous section.
13