The Copier Is Not Functioning As Designed - Minolta Di620 Operator's Manual

6-4

2. The Copier is not Functioning as Designed

The copier is not functioning as designed
Symptom
The Touch Panel shows nothing. Is only the Start key lit up green? The copier is in the Energy Saver
The Start key does not light up
green.
No copies are fed out when the
Start key is pressed.
Control panel keys do not
respond.
The copier is not activated when
the Power Switch is turned ON.
* If these procedures do not correct the problem, turn OFF the Power Switch, unplug the power cord from
the power outlet, and contact your Technical Representative.
Check for
Auto Shut Off is activated.
The Display Contrast Knob is
turned to the excessively light or
dark position.
Is your Access Number or
Account Number entered?
1155O398CA
The copier has developed a
malfunction.
The copier was just turned ON
and is warming up.
The Interrupt key LED is lit up.
1166O260AA
The power cord is left unplugged
from the power outlet.
The room circuit breaker is
open.
Action
mode. Press any key on the
control panel to cancel Energy
Saver mode.
Turn the Power Switch ON.
Viewing the Touch Panel, adjust
the Display Contrast Knob as
necessary.
Enter your Access Number or
Account Number by following
the procedure given in "Entering
the Access Number."
p. 2-20
Check the Touch Panel and take
action according to the message
on the panel.
It takes the copier about 7 min.
to be ready for making copies
after it has been turned ON.
Please wait.
The copier is in the interrupt
mode. Press the Interrupt key to
cancel the interrupt mode.
Plug the power cord into the
power outlet.
Close the room circuit breaker.