Base Settings - AT&T E2562 User Manual

ATT-2562CIB-d4.qxd 12/29/2003
Select MENU
BASE
RDL MENU MEM
Select SETUP BASE
CALL HISTORY
MAILBOXES
SETUP BASE
DISPLAY BASE ID
^ V
OK
Scroll to choose desired item
RINGERS
CALL SCREENING
SET PULSE/TONE
KEYPAD TONE
^ V
OK
Press OK to select
CONTRAST
ENHANCED MODE
RENAME
DEREGISTER ALL
^ V
OK
6:23 PM Page 15
Telephone Operation

Base settings

Ringers
At this menu you can set default ring volumes, or turn the
ringer off. You can also select one of six call melodies.
Settings are selectable for the intercom and each line.
Follow the menu instructions to select the volume and
melody you prefer, then press
Call screening
Call screening lets you hear messages as callers leave
them. Press or , then press
ON OFF
Set pulse/tone
Factory default setting for both lines is
to only if you do not have touch-tone dialing ser-
PULSE
vice (select line, select
TONE
Keypad tone
The handset is factory programmed to beep at each
keypress. Press or
ON OFF
Contrast
At this menu you can adjust screen contrast to one of 16
<>
levels. Use the buttons to select the level you prefer,
then press to confirm.
OK
Enhanced mode
^V
Use the buttons to select On, Off or Auto for all
handsets, then press
OK
mode may improve sound quality and range, but will use
more battery power. In Auto mode, handsets switch to
Enhanced Mode when reception is poor.
Rename
Select Rename to change the name (up to 14 letters) that
identifies your handset in all Intercom/Transfer menus
(see page 17 to enter letters). Press
Deregister all
Use this option with caution. It will make all handsets
unusable until each has been re-registered (see page 36).
15
or to confirm.
OK SAVE
to confirm.
OK
. Change this
TONE
or , then press
PULSE
, then press to confirm.
OK
to confirm. When on, this
to confirm.
SAVE
).
OK