ATT-2562CIB-d4.qxd
12/29/2003
Getting Started
Telephone base installation (separate line jacks)
If you have separate jacks for each line, install the base as shown below. Choose a
location away from electronic equipment, such as personal computers, television sets
or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Line 1
Line 2
Connect clear
line cord to jack
labeled LINE 1
Line identification
To identify phone lines, press
then call one of your telephone numbers. If you
hear a busy signal, Line 1 is the number you called.
If Line 2 rings, it is the number you called.
6:20 PM
Page 7
Connect black line cord
to jack labeled LINE 2
,
SPEAKERPHONE
7
Plug base power
cord transformer
into electrical outlet
Connect handset cord
to base handset
NOTE: Use only the power
cord supplied with this product.
If you need a replacement, call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.